An estimating card gives a screening-level installed cost for one piece of equipment, from the published PEICI factor set. It is an order-of-magnitude figure for deciding whether something is worth studying — not a quotation, and not a basis for capital approval.
What the calculator does
Every estimate uses five published parameters and nothing else, so you can reproduce any number it gives you by hand:
- Reference size and reference cost — a point on the curve that was actually fitted to data.
- Equipment exponent — how equipment cost scales with capacity.
- Installed exponent — how installed cost scales, which is not the same number.
- Installed-cost multiple at the reference size — the ratio between the two at that point.
The two exponents are the reason the tool exists. The installed-cost multiple is not a constant: it falls as plant gets larger, because installation scales more slowly than equipment. A calculator that applies one fixed multiplier under-prices small plant badly, and small plant is most of what our clients build.
Accuracy
Results are labelled AACE Class 5 — order of magnitude, concept screening, 0–2% project definition. The band is asymmetric: roughly −20% to +30% at best, −50% to +100% at worst. It is shown asymmetric because that is what it is, and averaging it into a single ± figure would misrepresent the risk.
The calculator refuses to produce a number outside each equipment’s published validity range rather than extrapolating. A power law fitted over one range does not hold outside it.
The four cards
- Heat — boilers, process heaters and thermal storage.
- Generation and storage — solar and battery storage.
- Grid and enabling — transformers and connection equipment.
- Rotating and cooling — compressors, pumps and cooling towers.
Where the numbers come from
The factor tables, the fitted exponents and the method are all published and free to read — see the Cost Index and the exponent register. The calculator is the tool that applies them; the data itself is never gated.